成人动漫在线观看 I 免费看大片a I 亚洲另类av I 久久精品视频一区 I 秋霞中文字幕 I 不卡视频一区二区 I 性色在线 I 爽妇综合网 I 黄色的一级片 I 美女靠逼app I 色播欧美 I 久色悠悠 I 日本久久黄色 I 非洲黑寡妇性猛交视频 I 亚洲乱码国产乱码精品精大量 I 看特级黄色片 I 一二三区在线播放 I 久久激情婷婷 I 欧美日韩国产成人精品 I 国产三级国产精品国产专区50 I 911视频完整版在线观看 I 色婷婷aⅴ一区二区三区 I 美女视频福利网站 I 操久久久久久 I 揉着我的奶从后面进去视频 I 各种少妇bbw撒尿484613 I 自拍偷拍 网站 I 亚洲人 屁股 鞭打网站

其中一段,誰能給我解釋一下啊????

Reading Consistent Data of a DP Standard Slave//PROFINET IO Device with SFC 14 "DPRD_DAT"
Description

With SFC 14 "DPRD_DAT" (read consistent data of a DP standard slave), you read the consistent data of a DP standard slave/PROFINET IO device.

To find the maximum length that applies for S7-300 CPUs, refer to the manuals, Automation System S7-300, Hardware and Installation, ET?00S Interface Submodule, IM151-7 CPU, or Base Submodule BM147CPU. For S7-400 CPUs refer to the manual Automation System S7-400 CPU Data. If no error occurred during the data transfer, the data that have been read are entered in the destination area identified by RECORD.

The destination area must have the same length as configured for the selected module with STEP 7.

If you read from a DP standard slave with a modular design or with several DP identifiers, you can only access the data of one module/DP identifier per SFC 14 call specifying the configured start address.

Writing Consistent Data to a DP Standard Slave/PROFINET IO Device with SFC 15 "DPWR_DAT"
Description

With SFC 15 "DPWR_DAT" (write consistent data to a DP standard slave), you transfer the data in RECORD consistently to the addressed DP standard slave/PROFINET IO device and, if required, to the process image (namely if you have configured the respective address area of the DP standard slave as consistency range in a process image). To find the maximum length of the data to be transferred for S7-300 CPUs, refer to the manuals, Automation System S7-300, Hardware and Installation, ET?00S Interface Submodule, IM151-7 CPU, or Base Submodule BM147CPU. For S7-400 CPUs refer to the manual Automation System S7-400 CPU Data. The data is transferred synchronously, in other words, on completion of the SFC, the write job is also completed.

The source area must have the same length as you configured for the selected module with STEP 7.

If the DP standard slave has a modular design, you can only access one module of the DP slave.

看樣子你的程序是上傳得來的？或者是供貨商根本就不想讓你看源程序？

不是上載的還要問嗎???